Rane MP 24Z Instruções de Operação Página 4

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 9
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 3
Manual-4
REAR PANEL DESCRIPTION
BALANCED MAIN OUTPUT connectors: Provide a fully balanced Main Output signal—pin 2 is (+), pin 3 is () and pin
1 is signal ground. Pin 3 must never be grounded for unbalanced operation. Use only pin 2 as hot and pin 1 as return for
any unbalanced operation.
UNBALANCED MAIN OUTPUT connectors: Provide MAIN OUTPUT signals on ¼" TS (tip-sleeve) unbalanced
connections.
BOOTH OUTPUT connectors: The Left Output only supplies a mono BOOTH monitor Output; connecting to both Left
and Right provides a stereo Output.
ZONE OUTPUT connectors: The Left Output only supplies a mono ZONE OUTPUT, connecting to both Left and Right
provides a stereo Output. The Zone Outputs are located Post-EQ, which includes the Microphone Output. An internal
jumper block programs the Zone to Pre-EQ (and no mic) if required. (See Service Information on page Manual-9.)
MAXIMUM OUTPUT GAIN REDUCTION control: Decreases the maximum Level of the balanced and unbalanced
MAIN OUTPUTS of the MP 24z as it is rotated CCW.
METER SENSITIVITY ADJUST: Clockwise rotation decreases the full-scale sensitivity of the PEAK PROGRAM
METER, as indicated by the full-scale voltage calibrations around the control.
SYSTEM MONO/STEREO switch: Engaging this pushbutton converts all Outputs (except tapes and loops) to MONO,
regardless of the nature of the Input signals.
EQ RANGE switch: In the out position, the maximum boost/cut available from the Program Equalizer is ±8 dB. In the
switch’s in position, this range is reduced to ±4 dB.
LIGHT CONTROL OUTPUT jack: Provides a transformer-coupled mono program signal for use by a lighting
controller’s trigger input. This is a balanced ¼" output—the tip is positive, the ring is negative and the sleeve is floating.
LIGHT OUTPUT LEVEL attenuator: Counter-clockwise rotation reduces the Output Level at the LIGHT CONTROL
OUTPUT jack.
Vista de página 3
1 2 3 4 5 6 7 8 9

Comentários a estes Manuais

Sem comentários