Rane MX 22 Manual do Utilizador descarregar pdf

Manual-1

QUICK START

Whoa, hold on there. Even if you don’t read manuals as a matter of principle, at least read this section to avoid hurting

yourself or your equipment.

Connect the MX 22 with the power off. Balanced XLR cables are recommended, but if you must convert to ¼" connec-

tors, buy or make a cable like the ones on page Manual-11 and keep them as short as possible. This device uses low imped-

ance balanced line drivers. Do not connect the “+” or “–” output pins to ground, as this may cause the power supply to

shut down. For unbalanced use, leave the unused output pin (“+” or “–”) unterminated.

Consult the speaker manufacturer for the correct crossover FREQUENCY setting. As rugged as some drivers are, many

(especially compression drivers) will not accept frequencies outside of their normal range without producing distortion and

possibly self-destruction.

With all equipment turned off and LEVEL controls down, begin making connections to the system as shown on page

Manual-4 or 5. When turning on the system, switch on the power amplifiers last. Now, feed the MX 22 some program

material. Start by turning up the LOW LEVEL and HIGH LEVEL to the 0 dB marks. Slowly increase the INPUT

LEVEL, even if it goes all the way to 10, so the +4 dBu (green) light blinks occasionally and the OL (red) light stays out.

This delivers the best signal-to-noise performance.

The MONO SUB OUTPUT is a sum of the Left and Right Low Outputs. The MONO SUB LEVEL adjusts only this

Output and is not affected by the LOW LEVEL control.. When using a single subwoofer along with full-range cabinets

that have internal crossovers, set the 100 Hz FILTER to OUT, allowing the front panel FREQUENCY to control the

subwoofer crossover point. When used with biamp cabinets and a subwoofer, set the 100 Hz FILTER switch to IN to

allow only frequencies below 100 Hz at this output jack. This way, the MX 22 almost does the job of a Stereo 3-Way

crossover, but without removing that awesome bass from the Left and Right Low Outputs.

WEAR PARTS: This product contains no wear parts.

OPERATORS MANUAL MX 22

STEREO 2-WAY CROSSOVER

1 2 3 4 5 6 ... 10 11

Resumo do Conteúdo

Página 1 - OPERATORS MANUAL MX 22

Manual-1QUICK STARTWhoa, hold on there. Even if you don’t read manuals as a matter of principle, at least read this section to avoid hurtingyourself o

Página 2 - IMPORTANT SAFETY INSTRUCTIONS

Manual-9VARIOUS XLR CABLE ASSEMBLIES

Página 3

Manual-10©Rane Corporation 10802 47th Ave. W., Mukilteo WA 98275-5098 TEL (425)355-6000 FAX (425)347-7757 WEB http://www.rane.comMOJO GLOSSARYbal

Página 4

RISK OF ELECTRIC SHOCKDO NOT OPENCAUTIONTo reduce the risk of electrical shock, do not open the unit. No user serviceable parts inside. Refer servicin

Página 5

Manual-2INPUT LEVEL control andindicatorsThis controls the overall level withoutaltering the relative settings of the Low andHigh frequency Outputs. I

Página 6

Manual-3Power ON switch and LEDYour basic, straightforward power switch.When the yellow LED is lit, the MX 22 isready to go.LOW/HIGH FREQUENCY control

Página 7 - OPERATING INSTRUCTIONS

Manual-4APPLICATION — ACTIVE 2-WAY WITH (or without) MONO SUBUse this configuration if you have separate speaker inputs for the lowand high drivers, r

Página 8 - Manual-7

Manual-5Use this configuration if you have full-range cabinets with passivecrossovers built-in, i.e., no separate speaker inputs for the low andhigh d

Página 9 - SOUND SYSTEM INTERCONNECTION

Manual-6Setting the Output Level ControlsThe INPUT LEVEL is an overall system sensitivityadjustment. Use this control to decrease the overall sensitiv

Página 10 - VARIOUS XLR CABLE ASSEMBLIES

Manual-7Setting the Mono Sub Output LevelBegin with the MONO SUB OUTPUT LEVEL trim set atMAX. The LOW LEVEL control has no affect on the MONOSUB OUTPU

Página 11 - MOJO GLOSSARY

Manual-8SOUND SYSTEM INTERCONNECTIONproperly, connecting both ends of the shield is not oftenpracticed, since doing so can create noisy interconnectio

Comentários a estes Manuais

Sem comentários

Rane MX 22 Manual do Utilizador

Consulte online ou descarregue Manual do Utilizador para Áudio Rane MX 22. Rane MX 22 User Manual Manual do Utilizador

Resumo do Conteúdo

Comentários a estes Manuais

Manuais e produtos relacionados com Áudio Rane MX 22